This EFI 351W Hi-Ram manifold comes with a 105MM 1986-95 Ford 5.0 throttle body flange side mount top. The runner length and tapered cross section design will perform well for a wide range of engine combinations. The engineering team also redesigned the water crossover passage to allow room for distributor phasing. Aggressive, bold, race-bred styling will make bad intentions clear for drag race, muscle car, marine, off-road, sandrails, pulling trucks, track, street-rod applications and more! Manifold is designed for a 9.5" deck height.
- Runner length and the tapered cross-section designed to perform well for a wide range of engine configurations
- EFI fuel rails are machined for -8AN O-ring Fittings with passages large enough to accommodate high fuel flows and dampen pressure pulsations in the fuel system and come standard with EFI Hi-Ram kits.
- Cast aluminum construction. *** Requires the Use of Holley EFI Dual Sync Distributor - 565-111
Features:
- EFI fuel rails are machined for -8AN o-ring fittings with passages large enough to accommodate high fuel flows and dampen pressure pulsations in the fuel system and come standard with EFI Hi-Ram kits.
- Plenum Top Gasket Type – 3/32” Round O-ring Cord
- Manifold is designed for a 9.5" deck height.
- The 351W manifold is available to work with 105MM throttle bodies
- Ford 5.0 throttle body fitment
- Lid has been verified to fit under Cervinis 2.5” cowl hood on 1979-1993 Mustangs with 351W & 302W Hi-Ram bases when using motor mounts that retain stock engine locations.
- Designed for side mounted throttle bodies
- Allows room for designing boosted applications
- Requires the Use of Holley EFI Dual Sync Distributor - 565-111
- Engine Block Style:
- Stock/OEM standard deck
- Style:
- Tunnel Ram/Multi-port
- Basic Operating RPM Range:
- 1,500-7,000
- Material:
- Aluminum
- Finish:
- Natural
- Height:
- N/A
- Intake Section Included:
- Complete
- Multi-Port Fuel Rails Included:
- N/A
- Carburetor Quantity:
- N/A
- Carburetor Mounting:
- N/A
- Throttle Body Bore Size:
- 105mm
- EGR:
- No
- Has Bosses:
- Yes
- Bosses Machined:
- Yes
- Boss Quantity:
- Eight
- Injectors Included:
- No
- Fuel Rails Included:
- Yes
- Aftermarket Fuel Rail Required:
- No
- Throttle Body Included:
- No
- Quantity:
- Sold as a kit.
- Notes:
- For applications with 9.500 in. deck height. Fuel rails are machined for -8 AN O-ring fittings. A low-profile distributor will be needed when using this manifold. Uses 1986-95 Ford 5.0L throttle body flange.
