Moroso 63566 LS Gen III/IV Electric Water Pump, 1 in. NPT Female Inlet, Billet Aluminum, Clear Anodized, Each

The Moroso LS electric water pump mounts directly to the stock water pump location. Weighs 8.66 lbs. Eliminates bulky LS water pump with a more compact, cost- effective pump. Drive belt is eliminated to save horsepower, while providing maximum circulation for cooling efficiency during all driving conditions, especially while idling. Compatible with 12 and 16 volt systems. Draws normally with 12V (8-10 amps in a typical system), so it can be used on drag racing cars without an alternator.

Can be used with Moroso No. 63836 Alternator/Vacuum Pump Mount
Requires the use of a Remote THermostat Housing such as part No. 63425 or 63426

Emissions Warning
Products sold on this website may not be legal for use on public roads or highways due to Environmental Protection Agency (EPA) restrictions or California Air Resources Board (CARB) emissions regulations. Federal and State regulations may restrict Product installation to pre-emissions regulation (Model Year 1974 or earlier) or to competition/racing vehicles used exclusively in
1) events organized by recognized bodies, authorizing permits for participating drivers.
2) racing event qualification, and3) practice associated with events.
Installation of such products, including driving racing vehicles to and from the track, may be considered illegal “tampering ” or as “defeat device”, and may result in federal and state penalties. It is the purchaser’s responsibility to ensure compliance with all applicable emissions laws, including California’s stricter standards.

Proposition 65 Warning:
This product may contain chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm. For more information, visit www.P65Warnings.ca.gov.