Reducer spacers fit into 5/8in. rod ends, reducing the hole size for 1/2 in. hardware while also spacing the rod end away from chassis brackets. Standard spacers have a 3/4 in. O.D. and flanged spacers have a 1in. O.D. flange to help support rod end. Size referenced indicates the amount of space between rod end pivot ball and chassis bracket. Package of 2.
Emissions Warning
Products sold on this website may not be legal for use on public roads or highways due to Environmental Protection Agency (EPA) restrictions or California Air Resources Board (CARB) emissions regulations. Federal and State regulations may restrict Product installation to pre-emissions regulation (Model Year 1974 or earlier) or to competition/racing vehicles used exclusively in
1) events organized by recognized bodies, authorizing permits for participating drivers.
2) racing event qualification, and3) practice associated with events.
Installation of such products, including driving racing vehicles to and from the track, may be considered illegal “tampering ” or as “defeat device”, and may result in federal and state penalties. It is the purchaser’s responsibility to ensure compliance with all applicable emissions laws, including California’s stricter standards.
Proposition 65 Warning:
This product may contain chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm. For more information, visit www.P65Warnings.ca.gov.
- Inside Diameter (in.):
- 0.500 in.
- Outside Diameter (in.):
- 1.000 in.
- Thickness (in.):
- 0.250 in.
- Material:
- Steel
- Spacer Finish:
- Zinc Plated
- Quantity:
- Sold as a pair.
- Notes:
- Fits into a 5/8 in. rod end to reducing the hole size and spacing the rod end.