Designed for street, moderate strip and circle track applications. Forged steel heat-treated for added strength. Machined to the tightest tolerances.
- Fits 62-87 Ford 9 inch.
- 11-3/4" oval housing
- 10 bolt ring gear. 9.00" Ring gear diameter.
- 1.313" pinion diameter.
- 28 spline pinion
ADDITIONAL PARTS NEEDED:
BEP30125 Installation Kit open
BEP30127 Installation Kit 3.062" large bearing
BEP30125 Cross Pin chrome moly
BEP31026 Mini Spool 28 spline axles
BEP31027 Mini Spool 31 spline axles
BEP31001 Lightweight Spool 28 spline/3.062"
BEP31003 Lightweight Spool 31 spline/3.062"
BEP31006 Lightweight Spool 35 spline/3.250"
BREAK IN PROCEDURE: Drive vehicle NORMALLY for twenty minutes and let the gear cool down. Than drive vehicle NORMALLY again for another twenty minutes and let the gear cool down. The break in period is very important for lapping the load and coast pattern of the gear mesh. This break-in procedure prevents gear noise, stress points to develop when the gear is properly set up to manufacturer's specifications. Periodically check the oil level to make sure the case is full of clean gear lubricant and the oil stays relatively cool to touch by cover or housing inspection for MAXIMUM Gear life. Either Mineral Hypoid gear oil or Synthetic gear lubricants are recommended.
Not lubricant sensitive.
Features
- Differential Case Design Type:
- Ford 9 in.
- Ring and Pinion Ratio:
- 5.14:1
- Cover Bolts:
- 10
- Ring Gear Bolts:
- 10
- Pinion Spline Count:
- 28
- Ring Gear Rotation:
- Standard
- Ring Gear Teeth:
- 36
- Pinion Gear Teeth:
- 7
- Ring Gear Diameter (in.):
- 9.000 in.
- Pinion Shaft Diameter (in.):
- 1.313 in.
- Installation Kit Included:
- No
- Quantity:
- Sold as a set.
- Axle Model:
- Ford 9 in.