Performer Intake Manifold and Matching Cam/Lifter Packages (Idle to 5500 RPM)
Edelbrock Performer intake manifolds provide excellent performance from off-idle to 5500 RPM. Manifolds have a patented runner design for higher horsepower across a broader RPM range. Most Performer manifolds are direct replacements for stock manifolds, work with stock cylinder heads, and will accept the stock carburetor and all emissions equipment. Significantly enhance performance by using a matched Performer cam and lifter kit, specially formatted to improve engine output within the same RPM range. All manifolds are 50-state legal.
Emissions Warning
Products sold on this website may not be legal for use on public roads or highways due to Environmental Protection Agency (EPA) restrictions or California Air Resources Board (CARB) emissions regulations. Federal and State regulations may restrict Product installation to pre-emissions regulation (Model Year 1974 or earlier) or to competition/racing vehicles used exclusively in
1) events organized by recognized bodies, authorizing permits for participating drivers.
2) racing event qualification, and3) practice associated with events.
Installation of such products, including driving racing vehicles to and from the track, may be considered illegal “tampering ” or as “defeat device”, and may result in federal and state penalties. It is the purchaser’s responsibility to ensure compliance with all applicable emissions laws, including California’s stricter standards.
Proposition 65 Warning:
This product may contain chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm. For more information, visit www.P65Warnings.ca.gov.
- Engine Block Style:
- Stock/OEM standard deck
- Style:
- Dual plane
- Basic Operating RPM Range:
- Idle-5,500
- Material:
- Aluminum
- Finish:
- Natural
- Height:
- 4.850 in.
- Intake Section Included:
- Complete
- Throttle Body Bore Size:
- 4-barrel square bore
- Has Bosses:
- No
- Bosses Machined:
- No
- Boss Quantity:
- N/A
- EGR:
- No
- Quantity:
- Sold individually.
- Notes:
- Will not accept Motorcraft spread bore carburetor. Will not work with '69 and earlier cylinder heads. Two center bolt holes offset. Do not use competition style intake gaskets for this street manifold. A factory metal valley tray gasket along with a
- Make:
- American Motors
- Engine Family:
- AMC V8 Gas
- Engine Sizes:
- 5.0L/304-6.6L/401
- Years:
- 1970-1979
- Cylinder Head Style:
- Stock configuration
