Edelbrock 5076 Torker II 340/360 Intake Manifold, Square Bore, Single Plane, Aluminum, Natural, Small Block Mopar, Each

Torker II Intake Manifold and Matching Cam/ Lifter Packages (2500 to 6500 RPM)

The Edelbrock Torker II Manifold is a single-plane, low-rise in-take for high RPM, high-performance. The Torker II produces gains in top-end horsepower, with good throttle response in the 2500 to 6500 RPM range. Torker-Plus camshaft kits are matched to the manifolds for horsepower and torque gains throughout the same RPM range. Torker II intake manifolds have no provision for EGR.

Emissions Warning
Products sold on this website may not be legal for use on public roads or highways due to Environmental Protection Agency (EPA) restrictions or California Air Resources Board (CARB) emissions regulations. Federal and State regulations may restrict Product installation to pre-emissions regulation (Model Year 1974 or earlier) or to competition/racing vehicles used exclusively in
1) events organized by recognized bodies, authorizing permits for participating drivers.
2) racing event qualification, and3) practice associated with events.
Installation of such products, including driving racing vehicles to and from the track, may be considered illegal “tampering ” or as “defeat device”, and may result in federal and state penalties. It is the purchaser’s responsibility to ensure compliance with all applicable emissions laws, including California’s stricter standards.

Proposition 65 Warning:
This product may contain chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm. For more information, visit www.P65Warnings.ca.gov.