Hard Blok Water Jacket Filler is a specially formulated, cement-based product with refined, size-graded iron particles combined at an optimum ratio to provide maximum strength, vibration dampening, and heat dissipation required in high performance race engines. Its coefficient of thermal expansion is identical to cast iron engine blocks. Product has been tested and proven effective in aluminum blocks.
Order the TALL FILL Unit for 350 cubic inch and larger blocks. Order the SHORT FILL Unit for circle track and street rod applications. Detailed instructions and contingency decals are shipped in each unit. To avoid coolant flow restrictions, check flow requirements and the pattern of your particular block before filling. HARD BLOK becomes permanent and cannot be removed after hardening. H & H Specialties, Inc. cannot be responsible for any coolant flow blockage or overheating problems caused by installation of water jacket filler.
NOTES: Block castings are not precise. One side may vary from the other. Variance between blocks can be considerable. H & H is not responsible for this variance. One TALL FILL Unit will fill most big blocks to the bottom of the water pump connection. In certain tall deck blocks, the fill level may be an inch or so lower. This level is adequate to stiffen the cylinder walls.
WARRANTY: No warranty is stated nor implied due to operating extremes in race engines and manufacturer's inability to control installation. Manufacturer is not responsible for any cooling problems that may result from filling water jackets. User is responsible for determining suitability of product for intended use. All risk and liability connected with use of the product is assumed by user.
Features
- Quantity:
- Sold as a kit.
- Notes:
- Kit includes two 14 lb. bags.
