This fully terminated harness is compatible with HP and Dominator ECU's and is plug and play w/ the following products:
554-118-HALL EFFECT CRANK TRIGGER SENSOR
554-124-FERROUS TARGET CRANK SENSOR
554-125-FLYING MAGNET CAMSHAFT SENSOR
554-127-CAMSHAFT SENSOR W/ FLYING MAGNET TARGET
556-114-BBC CAM SYNC KIT W/BRACKET
556-119-SBC CAM SYNC KIT W/BRACKET
Instructions
Instructions - 558-431_crank-cam_ignition_harness_diagram.pdf
Attention
This part is legal for sale or use on Racing Use Only Vehicles
The following vehicles are considered Racing Use Only Vehicles
Racing Use Only Vehicles are vehicles that are used exclusively for competition that are not registered and that may never be used on the street.
WARNING: It is against the law to install this part on an Emissions Controlled Vehicle
Emissions Warning
Products sold on this website may not be legal for use on public roads or highways due to Environmental Protection Agency (EPA) restrictions or California Air Resources Board (CARB) emissions regulations. Federal and State regulations may restrict Product installation to pre-emissions regulation (Model Year 1974 or earlier) or to competition/racing vehicles used exclusively in
1) events organized by recognized bodies, authorizing permits for participating drivers.
2) racing event qualification, and3) practice associated with events.
Installation of such products, including driving racing vehicles to and from the track, may be considered illegal “tampering ” or as “defeat device”, and may result in federal and state penalties. It is the purchaser’s responsibility to ensure compliance with all applicable emissions laws, including California’s stricter standards.
Proposition 65 Warning:
This product may contain chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm. For more information, visit www.P65Warnings.ca.gov.
