Moroso 37934 Bellhousing Dowel Pin, Extra Long, 1.328 in Long, 0.625 in Diameter, 0.007 in Offset, Steel, GM V6 / V8, Pair

$27.99
MSRP: $35.09
(You save $7.10 )
(No reviews yet) Write a Review
SKU:
MOR37934
MPN:
37934
UPC:
84663379345
Condition:
New
Weight:
0.24 LBS
Shipping:
Calculated at Checkout

Applies To Continental U.S. orders only

Adding to cart… The item has been added

Bellhousing Dowel Pins, .007 offset, 1.328 long

Features
  • Provides an easy method of properly aligning the transmission input shaft to the crankshaft pilot bearing
  • Extra long to simplify the task of installing a bellhousing on the engine block
  • Offset Dowel Pins include set screws and instructions for locking pins into place drilling and tapping of block required
  • Getting alignment concentric to within ± .005" insures a clean clutch release, maximum pilot bearing and transmission life and reduced shifting problems
  • .625" diameter
  • Two per package
  • Fits virtually all GM V8 and V6 blocks

Emissions Warning
Products sold on this website may not be legal for use on public roads or highways due to Environmental Protection Agency (EPA) restrictions or California Air Resources Board (CARB) emissions regulations. Federal and State regulations may restrict Product installation to pre-emissions regulation (Model Year 1974 or earlier) or to competition/racing vehicles used exclusively in
1) events organized by recognized bodies, authorizing permits for participating drivers.
2) racing event qualification, and3) practice associated with events.
Installation
 of such products, including driving racing vehicles to and from the track, may be considered illegal “tampering ” or as “defeat device”, and may result in federal and state penalties. It is the purchaser’s responsibility to ensure compliance with all applicable emissions laws, including California’s stricter standards.

Proposition 65 Warning:
This product may contain chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm. For more information, visit www.P65Warnings.ca.gov.

Dowel Pin Offset (in.):
0.007 in.
Dowel Pin Length (in.):
1.500 in.
Dowel Pin Diameter (in.):
0.625 in.
Quantity:
Sold as a pair.
Notes:
These dowel pins are manufactured to a .625 specification. However, they do have a + / - .005 tolerance.