Ford 429-460 Electric Water Pumps Height: 4.75 inch Weight: 7.00 lbs.
Features
- Low profile and pocketed pump plates remove unnecessary weight
- Electric motor with heavy-duty windings, precision balancing, long-life brushes, stainless steel shaft and sealed ball bearings
- Mounts directly to stock water pump location, includes stainless steel mounting hardware & gasket for simple installation
- Eliminates driving belt and fan to save weight and horsepower, while providing maximum circulation to improve cooling efficiency during all driving conditions, especially while idling
- Compatible with 12 and 16 volt systems
- High-temperature Viton® seal eliminates leaks
- Machined with new -16AN port (except B.B. Mopar) for easier installation of our new hose adapters, eliminating the need for Teflon tape or pipe sealants
- Pumps can easily accommodate lower radiator hose from either driver or passenger side installations
- Clear anodized 6061-T6 billet aluminum pump housing, impeller, pump plate and motor cap along with powder-coated outer case will provide years of dependable operation
- Draws 8-10 amps in a typical 12V system, so it can be used on drag racing car without an alternator
Proposition 65 Warning:
This product may contain chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm. For more information, visit www.P65Warnings.ca.gov.
- Material:
- Aluminum
- Finish:
- Clear Anodized
- Flow Rate:
- 30-37 GPM
- Hose Adapter Included:
- No
- Hose Inlet Adapter Thread Size:
- -16 AN
- Inlet Hose Attachment:
- Female threads
- Hose Outlet Adapter Thread Size:
- N/A
- Outlet Hose Attachment:
- N/A
- Inlet Hose Size:
- -16 AN
- Amp Draw:
- 8.00-10.00 amps
- Gaskets Included:
- N/A
- Overall Depth (in.):
- 5.100 in.
- Weight:
- N/A
- Controller Included:
- 7.000 lbs.
- Quantity:
- Sold individually.
- Make:
- Ford
- Engine Family:
- Ford big block 385 Series
- Engine Sizes:
- 7.0L/429-7.5L/460
- Years:
- 1968-1997
- Backing Plate Included:
- No
