Due to the nature of U-joints, when using two on a shaft it is necessary to Mis-Phase the U-joints, this is the proper way to create the shaft. Mis-phasing is accomplished by making sure that the yokes attached to either end of a shaft are 90 degrees out of alignment as opposed to having the yokes aligned – or in phase. Placing the U-joints In-phase is a common misperception.
Steering Coupler with 9/16"-26 on one half, and 3/4" smooth on the other.
Emissions Warning
Products sold on this website may not be legal for use on public roads or highways due to Environmental Protection Agency (EPA) restrictions or California Air Resources Board (CARB) emissions regulations. Federal and State regulations may restrict Product installation to pre-emissions regulation (Model Year 1974 or earlier) or to competition/racing vehicles used exclusively in
1) events organized by recognized bodies, authorizing permits for participating drivers.
2) racing event qualification, and3) practice associated with events.
Installation of such products, including driving racing vehicles to and from the track, may be considered illegal “tampering ” or as “defeat device”, and may result in federal and state penalties. It is the purchaser’s responsibility to ensure compliance with all applicable emissions laws, including California’s stricter standards.
Proposition 65 Warning:
This product may contain chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm. For more information, visit www.P65Warnings.ca.gov.
- Shaft End 1:
- 9/16 in.
- Side 1 Connection:
- 26 Spline
- Shaft End 2:
- 3/4 in.
- Side 2 Connection:
- Smooth
- Material:
- Steel
- Finish:
- Natural
- Vibration Damper Included:
- No
- Wiring Harness Included:
- No
- Steering Shaft Included:
- No
- Quantity:
- Sold individually.
