Vibrant Performance 304 Stainless Steel Schedule 10 Weld Fittings are ideal for use in the fabrication of turbo exhaust manifolds and downpipes. The chamfered ends allow for easy butt welding. Sch. 10 Pipe = 0.109" (2.77mm) wall thickness.
Note:
Pipes are normally identified by a Nominal Pipe Size (NPS) rather than Outside Diameter. Please refer to the “Actual I.D.” and “Actual O.D.” columns on the application list below to ensure you choose the correct pipes for your project.
Emissions Warning
Products sold on this website may not be legal for use on public roads or highways due to Environmental Protection Agency (EPA) restrictions or California Air Resources Board (CARB) emissions regulations. Federal and State regulations may restrict Product installation to pre-emissions regulation (Model Year 1974 or earlier) or to competition/racing vehicles used exclusively in
1) events organized by recognized bodies, authorizing permits for participating drivers.
2) racing event qualification, and3) practice associated with events.
Installation of such products, including driving racing vehicles to and from the track, may be considered illegal “tampering ” or as “defeat device”, and may result in federal and state penalties. It is the purchaser’s responsibility to ensure compliance with all applicable emissions laws, including California’s stricter standards.
Proposition 65 Warning:
This product may contain chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm. For more information, visit www.P65Warnings.ca.gov.
- Outside Diameter (in.):
- 1.500 in.
- Bend Angle:
- Straight
- Material:
- Stainless Steel
- Finish:
- Natural
- Tubing Gauge:
- 0.109 in.
- Leg 1 Length (in.):
- 12.000 in.
- Quantity:
- Sold individually.
