Dual channel turbine design for maximum efficiency under high pressure and high temperature applications. Made in USA by TI Automotive (parent company of Walbro). All pumping components have been validated to OEM specifications for approved use in E85/flex fuel applications. 100% Authentic & Genuine Walbro/ TI Automotive E85 Racing In tank 450 LPH high pressure fuel pump. The F90000274 requires modifications to system wiring, fuel lines and the fuel module.
The innovative design of the DCSS 39/50 features a single impeller with two parallel rows of turbine blades. Designed for high performance engines exceeding 750hp.Designed for E85 or Gasoline applications. The blades feed two high-pressure pumping channels, as opposed to a conventional single-stage pump that uses an impeller with a single row of blades at its outer edge. This innovative design results in improved hot fuel flow, as well as minimal noise and current use, resulting in efficiency that’s 20 percent higher than conventional pumps. SPECIFICATIONS 465 lph @ 40 psi and 13.5V (14.1 amps) in gasoline Outlet diameter: 10mm (3/8") Diameter (upper body) 39mm Diameter (lower body) 50mm
Walbro TI Automotive TIA450-2 Fuel Pump
Outlet diameter: 10mm (3/8") Diameter (upper body) 39mm Diameter (lower body) 50mm
400-0085 Install kit has been discontinued and replaced by 400-1168
Features
- Fuel Pump Type:
- Electric In-tank
- Fuel Pump Voltage:
- 12 V
- Flow Rate:
- 119 gph/450 lph
- Fuel Pressure (psi):
- 135 psi
- Fuel Pressure Regulator Included:
- No
- Sending Unit Included:
- No
- Inlet Quantity:
- One
- Inlet Size:
- 10.00 mm
- Inlet Attachment:
- N/A
- Outlet Quantity:
- One
- Outlet Size:
- 10.00 mm
- Outlet Attachment:
- Barb
- Gasket Included:
- No
- Wiring Harness Included:
- No
- Mounting Bracket Included:
- No
- Hardware Included:
- No
- Pulley Included:
- No
- Quantity:
- Sold individually.
