Push/Pull Battery Disconnect Mounting Kit
Features- Allows you to mount a Battery Disconnect Switch Nos 74100, 74101, 74102 or 74108¬Ý(not included) to a roll cage tube with a weld-on bracket, then actuate it with this T-handle kit protruding through the rear panel
- Comes with brackets, swing arm linkage, 18" long aluminum tube actuator link, all necessary bushings, fasteners and complete instructions
- Aluminum parts are black anodized
Emissions Warning
Products sold on this website may not be legal for use on public roads or highways due to Environmental Protection Agency (EPA) restrictions or California Air Resources Board (CARB) emissions regulations. Federal and State regulations may restrict Product installation to pre-emissions regulation (Model Year 1974 or earlier) or to competition/racing vehicles used exclusively in
1) events organized by recognized bodies, authorizing permits for participating drivers.
2) racing event qualification, and3) practice associated with events.
Installation of such products, including driving racing vehicles to and from the track, may be considered illegal “tampering ” or as “defeat device”, and may result in federal and state penalties. It is the purchaser’s responsibility to ensure compliance with all applicable emissions laws, including California’s stricter standards.
Proposition 65 Warning:
This product may contain chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm. For more information, visit www.P65Warnings.ca.gov.
- Lever Type:
- Battery disconnect push/pull
- Lever Material:
- Aluminum
- Lever Finish:
- Black anodized
- Lever Length (in.):
- 18.000 in.
- Switch Included:
- No
- Mounting Bracket Included:
- Yes
- Mounting Hardware Included:
- Yes
- Emergency Off Decal Included:
- No
- Quantity:
- Sold as a kit.