Boots for Battery Disconnect Switches, Two per pack (1 ea. Black/Red)
Meets sanctioning body requirement that terminals on the master electrical cut-off switch be covered
- Perfect compliment to Moroso Part Nos 74100, 74101, 74102, and 74106
- Prevents the shorting out of exposed terminals
- When installed, creates a finished "clean look" to disconnect switch wiring
- Constructed out of high quality, pliable, race environment friendly rubber
- Accommodates 2 to 4 gauge wire and 1/2" to 3/8" terminal studs
- Can be installed before or after termination of remote fitting ends
Emissions Warning
Products sold on this website may not be legal for use on public roads or highways due to Environmental Protection Agency (EPA) restrictions or California Air Resources Board (CARB) emissions regulations. Federal and State regulations may restrict Product installation to pre-emissions regulation (Model Year 1974 or earlier) or to competition/racing vehicles used exclusively in
1) events organized by recognized bodies, authorizing permits for participating drivers.
2) racing event qualification, and3) practice associated with events.
Installation of such products, including driving racing vehicles to and from the track, may be considered illegal “tampering ” or as “defeat device”, and may result in federal and state penalties. It is the purchaser’s responsibility to ensure compliance with all applicable emissions laws, including California’s stricter standards.
Proposition 65 Warning:
This product may contain chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm. For more information, visit www.P65Warnings.ca.gov.
