The TITAN KING LS3 camshaft is designed for maximum effort strip cars using 6.0-6.2 liter LS engines equipped with rectangular port, LS3/L99/L92 style heads. The TITAN KING will have a heavy lope at idle and explosive power in a vehicle equipped with the proper high stall torque converter, rear axle ratio and supporting intake and exhaust that has been modified or designed for high flow.
This cam was designed for people looking to get the most out of their stock bottom end 6.0-6.2 liter engine with rectangle port heads. This camshaft was designed to fit without the need to fly-cut valve reliefs in the pistons, however, as always, it is the owner's/builder's responsibility to check to assure safe clearance.
The TITAN series cams are designed with our renowned smooth cam lobe design that provides quiet valve train operation and excellent upper rpm stability.
Recommended Accessories:
-Cam Motion .660" lift Dual Valve Spring Kit
-Cam Motion 5/16" .080" Wall Hardened Chromoly Pushrods
-Cam Motion High Performance Hydraulic Lifters
Emissions Warning
Products sold on this website may not be legal for use on public roads or highways due to Environmental Protection Agency (EPA) restrictions or California Air Resources Board (CARB) emissions regulations. Federal and State regulations may restrict Product installation to pre-emissions regulation (Model Year 1974 or earlier) or to competition/racing vehicles used exclusively in
1) events organized by recognized bodies, authorizing permits for participating drivers.
2) racing event qualification, and3) practice associated with events.
Installation of such products, including driving racing vehicles to and from the track, may be considered illegal “tampering ” or as “defeat device”, and may result in federal and state penalties. It is the purchaser’s responsibility to ensure compliance with all applicable emissions laws, including California’s stricter standards.
Proposition 65 Warning:
This product may contain chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm. For more information, visit www.P65Warnings.ca.gov.
- Cam Style:
- Hydraulic roller tappet
- Basic Operating RPM Range:
- 3,500-6,700
- Intake Duration at .050 inch Lift:
- 232
- Exhaust Duration at .050 inch Lift:
- 244
- Duration at .050 inch Lift:
- 232 int./244 exh.
- Advertised Intake Duration:
- 287
- Advertised Exhaust Duration:
- 299
- Advertised Duration:
- 287 int./299 exh.
- Intake Valve Lift with Factory Rocker Arm Ratio:
- 0.621 in.
- Exhaust Valve Lift with Factory Rocker Arm Ratio:
- 0.604 in.
- Valve Lift with Factory Rocker Arm Ratio:
- 0.621 int./0.604 exh.
- Lobe Separation (degrees):
- 112.5
- Computer-Controlled Compatible:
- Yes
- Material:
- Billet Steel
- Camshaft Gear Attachment:
- 3-bolt
- Valve Springs Required:
- Yes
- Grind Number:
- XA232/365-XA244/355-12.5+3
- Camshaft Manufacturers Description:
- Hydraulic Roller - Maximum performance Strip-Race. Heavy lope at idle and explosive power in a vehicle equipped with the proper high stall torque converter, rear axle ratio and supporting intake and exhaust that has been modified or designed for high
- Quantity:
- Sold individually.
- Make:
- Chevrolet
- Engine Family:
- Chevy small block Gen III/IV (LS-based engines)
- Engine Sizes:
- 6.0L/364-6.2L/376
- Years:
- 1999-2017
